ENG
1. Left button
2. Right button
3. Mouse wheel and button
4. Forward button
5. Backward button
6. DPI button
7. LED mode button
Connect
Connect the USB receiver to a USB-A port on
your computer. The mouse will automatically
connect to your computer wirelessly.
This mouse supports use with USB cable.
If you connect the mouse with a USB cable,
the mouse will charge and can be used at
the same time.
Charge
To charge the mouse, connect it with a USB
cable to a computer.
Power switch
On the underneath of the mouse there is
a power switch. You can change between 3
modes. Left, center or right.
Left = Power off.
Center = Power on. All LEDs are off.
Right = Power on. All LEDs are on.
LED mode button
Press the LED mode button to cycle through
different LED modes. One of the LED modes
turns off the LEDs on the sides but keeps
the other LEDs on.
DPI
Use the DPI button to change the
DPI. The default DPI settings are:
400/800/1600/2400/4800.
Customize the DPI settings by using our
software.
When the DPI is changed, the LED flashes 5
times to confirm the change.
USB polling rate
The default polling rate is set on 1000 Hz.
You can adjust the polling rate in 4 steps.
125/250/500/1000 Hz.
To change the polling rate use our soft-
ware.
LED light
When you change DPI, there is a corre-
sponding LED that changes color. The LED
color for each DPI setting can be changed,
by using our software.
You can turn off the LEDs with the power
switch underneath the mouse.
Cleaning
Clean the product by using a dry cloth.
Safety instructions
1. Keep the product dry. Keep it away from
all liquids.
2. Do not open up or try to repair the
product by yourself.
3. Keep the product and packaging out of
reach of children to prevent accidents and
choke hazards.
4. Do not drop or expose to shock damage.
Warranty
Please, see www.deltaco.eu for warranty
information.
Support
More product information can be found at
www.deltaco.eu.
Software
Download the software at
www.deltacogaming.com.
5