Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
NAILER OPERATION
Read section titled "SAFETY" (pages 4 – 8).
Ordinary
eyeglasses
adequate protection.
● Keep fi ngers AWAY from trigger and lock
lever when not driving nails to avoid
accidental discharge.
● Know and understand what trigger system
you are using.
Please read and understand "Methods of
operation" found below.
● Never place your hands or body closer than
8 inches (200 mm) from fi ring head when
using.
● Do not drive nails into other nails; nails can
ricochet and hurt someone.
● Do not actuate Nailer unless Nailer is placed
fi rmly against the workpiece.
● In order to avoid unwanted ejection of a nail
due to bouncing of the Nailer,
1) release trigger quickly when performing
trigger fi re.
● When working close to an edge of a
workpiece or at steep angles, or driving
fasteners into thin workpiece use care to
minimize chipping, splitting or splintering, or
free fl ight, ricochet or piercing of fasteners,
which may cause injury.
● Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
14
DANGER
● Operators and others
in work area must wear
safety glasses with
side shields which
conforms
to
Z87.1 specifi cations.
do
not
provide
WARNING
● Only person who have
read and understand
this MANUAL should
operate the Nailer.
● Never point tool at
yourself or others in
work area.
● Never use Nailer which is defective or
operating abnormally.
● Do not use Nailer as hammer.
● Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) elevating, lowering or otherwise moving
it to another location;
4) handing it to another person;
5) performing any maintenance or repairs;
ANSI
6) clearing a jam;
7) Nailer is outside of the operator's
supervision or control;
8) removing nails from the magazine;
9) adjusting nailing depth; and
10) attaching or removing the nose cap.
METHODS OF OPERATION
● After the lock lever has been pulled, nails
can be driven simply by pulling the trigger.
Do not touch the trigger or the lock lever
other than when driving nails.
● Do not drive one nail on top of another.
NOTE
When using the Nailer in low temperatures, operation
may be aff ected.
1. Using the trigger and lock lever
In addition to the usual trigger, this Nailer is equipped
with a lock lever that acts as a safety device. Nails are
driven by pulling the lock lever and then pulling the
trigger.
Trigger
2. Driving nails
1 Press the nail exit lightly against the position
where you want to drive the nail.
2 Pull the lock lever.
WARNING
Lock
1
lever
2
Trigger
Lock
lever
Tabla de contenido
