Kreg KHI-PULL Manual Del Propietário página 3

Remove the Non-Slip Pads from the backing
paper and apply them to the circular recesses
in the Edge Guide. Position the Edge Guide
between the inch scales on the bottom of
the Base. Insert the Hex Head Bolts into
the holes in the bottoms of the hexagonal
recesses and thread on the T-Knobs from the
top of the Base.
For Pulls: Insert the Drill Guides into the
slots on both sides of the center hole,
aligning the pointer on each Drill Guide with
the dimension on the Base that matches the
center-to-center dimension of your pull. The
Base features center-to-center dimensions
for common inch and metric pulls. Make sure
the indexing peg under the pointer on the
bottom face of the Drill Guide is seated in the
correct indexing notch in the Base. Thread
Knurled Nuts onto the Drill Guides from the
bottom of the Base.
Assembly
Pointer
Inch indexing notch
Pointer
Indexing peg
2
Millimeter
indexing notch