Kreg KHI-PULL Manual Del Propietário página 5

Mark a centerline for the pull or knob on the
workpiece. Chuck a
drill. Position the Cabinet Hardware Jig with the
Edge Guide against the edge of the workpiece
and the marked centerline in the Centerline
Window. Clamp the Jig to the workpiece, insert
the drill bit into the Drill Guide(s) and drill the
hole(s). Example shows the jig set up for a pull.
WARNING Whenever possible, clamp the
Cabinet Hardware Jig to the workpiece. If you
must hold the Jig in place with your hand, keep
hands and fingers away from the back face of the
workpiece when drilling.
ATTENTION To prevent chip-out as the drill bit
exits the workpiece, clamp a piece of scrapwood
to the back of the workpiece.
Additional Alignment Features: For
centering a knob up to 3½" [89mm] from the
top or bottom edge of a door, use the inch or
millimeter scales on the beveled edge of the
Base.
For aligning the Cabinet Hardware Jig at
distances beyond the 5" [127mm] capacity of
the Edge Guide, mark horizontal and vertical
centerlines on your workpiece, remove the
Edge Guide, and align the Jig by using the
Centerline Pointers at the edges of the Base
and the Centerline Window.
Using the Jig
⁄ " [4.5mm] drill bit into your
3
16
Centerline
window
Mark on scale
aligned with edge
Centerline
window
Horizontal
centerline
Marked
centerline
Centerline
Pointer
Vertical
centerline
4