Dometic PJS 1000 Instrucciones De Uso página 16

Operation
Charging stops automatically when the jump starter is fully charged:
✔ The LCD display shows the state of charge as 100 %.
✔ The "IN" indicator stops flashing and is displayed permanently.
Checking the state of charge
➤ Press the
button to switch the jump starter on.
✔ The LCD display shows the state of charge (fig. 3 B, page 4) between 0 % (discharged) and 100 % (fully
charged).
8.5 Using the LED flashlight
!
CAUTION! Risk of injury
Avoid looking directly into the LED flashlight as this may damage your eyes.
I
NOTE
The operation of the LED flashlight is not available during charging.
The LED flashlight offers three operating modes:
• Continuous light: The LED flashlight lights up continuously.
• Strobe light: The LED flashlight is flashing at a constant interval.
• SOS signal: The LED flashlight is flashing the SOS signal pattern.
➤ To use the LED flashlight and switch between the different operating modes, proceed as shown (fig. 5,
page 5).
8.6 Jump-starting vehicles
!
WARNING! Electrocution hazard and fire hazard
• Do not connect the two battery clamps together.
• Do not use battery clamps other than those provided.
• Observe both the required connection and disconnection sequence of the battery
clamps and the correct polarity.
!
CAUTION! Risk of injury
Do not put fingers or hands into the battery clamps.
A
NOTICE! Damage hazard
• Do not jump-start a deeply discharged or defective vehicle battery.
• Do not attempt to jump start the vehicle more than 3 times in a row. If the vehicle
does not start after 3 attempts, the vehicle should be checked by authorized work-
shops.
16
PJS1000
EN