Shindaiwa ES726 Manual De Instrucciones página 8

Idiomas disponibles

Idiomas disponibles

Starting the Engine (Cont.)
Choke Closed
Figure 13
6. Set the choke lever to the closed
position. See figure 13.
Figure 14
Stopping the Engine
Ignition "OFF"
Figure 16
Adjusting Engine Idle
Idle Speed
Screw
Figure 17
8
All manuals and user guides at all-guides.com
7. Hold the ES726 firmly with one hand.
Slowly pull the recoil starter handle
until resistance is felt, then pull
quickly to start the engine.
See figure 14.
CAUTION!
Do not pull the recoil starter to the
end of the rope travel. Pulling the
recoil starter to the end of the rope
travel can damage the starter.
Figure 15
Idle the engine briefly, then move the
ignition toggle switch to the "OFF"
position. See figure 16.
The idle speed must be adjusted so the
clutch will fully disengage at engine idle,
causing the pump to stop oscillating.
Check and Adjust Idle Speed
1. Start the engine and allow it to warm
up at low rpm.
2. If the pump oscillates at engine idle,
reduce idle speed by turning the idle
adjusting screw counter-clockwise.
See figure 17.
NOTE:
Standard idle speed is
3000, rpm +/– 250 rpm.
8. When the engine starts, slowly move
the choke lever to the "OPEN"
position. If the engine stops after the
initial start, close the choke and
restart. See figure 15.
If the engine fails to start after several
attempts with the choke in the closed
position, the engine may be flooded
with fuel. If flooding is suspected,
move the choke lever to the open
position and repeatedly pull the recoil
starter to remove excess fuel and start
the engine. If the engine still fails to
start, refer to the troubleshooting
section of this manual.
Choke Open
WARNING!
The pump must NEVER oscillate at
engine idle.
WARNING!
Fuel mixture has been preset at the
factory and further adjustment
should be made only by your
Shindaiwa authorized dealer.
IMPORTANT!
loading