Idiomas disponibles
Idiomas disponibles
Insert the universal end cut blade onto the accessory
interface (6), then (if necessary, re-insert the flange) press
down the flange with finger to keep the blade temporarily
secure. Flip lever (1) back down to seated position to secure
accessory. (See Fig. C)
MOUNTING / CHANGING THE SANDING
SHEET (See Fig. D, E)
2a) Flip the tool-less blade change lever (1) forward to the
open position to loosen the flange (7). Remove universal end
cut blade. Insert the sanding pad (12) onto the accessory
interface (6), then (if necessary, re-insert the flange) press
down the flange with finger to keep the blade temporarily
secure. Flip lever (1) back down to seated position to secure
accessory.
2b) Place the mesh sanding sheet directly onto the base
plate and press the sheet onto the pad. Firmly press the
oscillating tool with the installed sanding sheet against a flat
surface and briefly switch the power tool on. This provides
for good adhesion and prevents premature wear. If one
point has become worn after use, pull off the sanding sheet,
turn it 120°, and re-install.
2. OPERATING THE ON/OFF SWITCH
(See Fig. F)
-Switching the power tool ON:
Slide switch forward.
-Switching the power tool OFF:
Slide switch backward.
3. USING THE VARIABLE SPEED DIAL
(See Fig. G)
Select oscillation frequency (speed) while the motor is
running.
The Variable Speed Dial can be used to set the optimum
oscillating frequency according to the accessories used and
the respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone and metal.
Low oscillation frequency:
Scraping, polishing varnishes.
4. SIGHT LIGHT (See Fig. H)
The sight light allows you to keep a clear view under less
illuminated circumstances. To turn on the light, simply press
the on/off switch. When you release the on/off switch, the
light will turned off.
5. ELECTRONIC FEEDBACK
Your tool is equipped with an internal electronic feedback
system which helps keep the preselected speed virtually
constant between no-load and load conditions.
EN
WORKING HINTS FOR
YOUR TOOL
If your power tool becomes too hot, especially when used
at low speed, set the speed to maximum and run it with
no load for 2-3 minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always keep the blade sharp.
Always ensure the workpiece is firmly held or clamped to
prevent movement.
Any movement of the material may affect the quality of the
cutting or sanding finish.
Start your tool before working and turn it off only after you
stop working.
Do not start sanding without having the sandpaper fitted.
Do not allow the sandpaper to wear away, it will damage
the sanding pad. The guarantee does not cover sanding pad
wear and tear.
Use coarse grit paper to sand rough surfaces, medium grit
for smooth surfaces and fine grit for finishing surfaces. If
necessary, first make a test run on scrap material.
Excessive force will reduce the working efficiency and
cause motor overload.
Replacing the accessory regularly will maintain optimum
working efficiency.
MAINTAIN TOOLS WITH
CARE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
15
