Idiomas disponibles
Idiomas disponibles
GENERAL SAFETY
WARNINGS
WARNING: Read all safety warnings
and all instructions. Failure to follow the
warnings and instructions may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future
reference.
- This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for
their safety.
- Children should be supervised to ensure that they do not
play with the appliance.
Safety instruction for heat gun, hand-held
paint strippers and pipe soldering machine
A fire may result if the appliance is not used with care,
therefore
– be careful when using the appliance in places where there
are combustible materials;
– do not apply to the same place for a long time;
– do not use in presence of an explosive atmosphere;
– be aware that heat may be conducted to combustible
materials that are out of sight;
– place the appliance on its stand after use and allow it to
cool down before storage;
– do not leave the appliance unattended when it is switched
on.
EN
SYMBOLS
WARNING: Read the operator's manual.
Do not expose to rain or moisture.
SWITCH OFF: Remove plug from mains before
cleaning or maintenance.
OPERATION
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The unit is intended for the forming and welding of plastic,
removal of paint and warming of heat-shrinkable tubing. It is
also suitable for soldering and tinning, loosening of adhesive
joints and the defrosting of water lines.
BEFORE USING THE TOOL
Before starting the job it is advisable to test the workpiece
for the ideal temperature to use. The description below
gives an indication of the likely heat settings required but
always start with the low heat setting.
The distance between the nozzle and the workpiece will
vary according to the material being worked on but this
should always be at least 50mm (2inch) or more on either
heat setting.
All applications, with the exception of removing paint from
the window frames, can be performed without using a
nozzle; however for best results nozzles are recommended.
PUTTING INTO
OPERATION
1. SWITCHING ON/OFF
SWITCHING ON:
To put into operation, slide the switch (5) to position 1, 2
or 3.
9
