Parkside PDSP 1000 E6 Traduccion Del Manual De Instrucciones Originale página 8

NOTE REGARDING THE BLASTING
MEDIUM GRAIN SIZE
► The larger/coarser the grain size of the
blasting medium used, the coarser the dirt
that can be removed using it. The supplied
material, on the other hand, is fine and thus
more suitable for the removal of items such as
paint or rust film. The fine material also
causes less damage to the surfaces being
treated, meaning a choice can be made
regarding these.
For coarse rust, for example, it is best to use a
coarser-grained blasting medium which you
can buy online (see section "Importer") or in
any good specialist retailer. Please observe
the guidelines regarding maximum grain size.
Connecting the compressed air
supply
NOTE
► The compressed air sandblaster gun
only be operated on cleaned, condensate-
and oil-free compressed air and may not
exceed the maximum operating pressure of
6.3 bar at the appliance.
To ensure that you can regulate the air pres-
sure, the compressed air source should be
equipped with a (filter) pressure reducer.
♦ Connect the compressed air sandblaster gun
to a suitable compressed air source by attaching
the quick-connect coupling on the supply hose
to the nipple on the sandblaster gun
The connection locks automatically.
NOTE
► Ensure that the control dial
before connecting the appliance to the
compressed air source.
PDSP 1000 E6
Using the compressed air sandblaster
gun
■
NOTE
►
■
■
■
■
may
Switching on
■
■
■
Switching off
■
.
■
■
is set to
NOTE
►
Carefully prepare the workpiece that is to be
blasted.
Clean it if necessary.
Layers of dust or fat will significantly impair
the results.
Carefully cover or mask everything that is not to
be blasted.
The distance between the attachment and the
surface being worked plays an important role
and should be kept as low as possible so that
the blasting medium
collecting bag .
The nearer you are to the workpiece, the
smaller the dispersion pattern and vice versa.
Do a test run on an old workpiece to find out
the correct distance/working pressure and
avoid excessive reflection from your workpiece.
Set the control dial
outlet.
Move the compressed air sandblaster
to the area to be worked.
Press the trigger to start operating the
compressed air sandblaster gun
Release the trigger
compressed air sandblaster gun
Set the control dial
outlet.
Disconnect the appliance from the compressed
air source after you finish work.
First detach the hose from the compressed air
source before disconnecting the supply hose
from the appliance.
In this way, you avoid uncontrollable
thrashing about of the supply hose.
can be collected by the
to to open the air
close
.
to switch off of the
.
to to close the air
GB │ IE │ 5 ■