Topping Up The Oil; Connecting To A Compressed Air Source - Parkside PDBNP 14 A1 Traducción Del Manual De Instrucciones Original

Topping up the oil

To ensure that the rivet gun remains operational for as long as possi-
ble, make sure that there is sufficient pneumatic oil in the appliance.
The following options are available:
♦ Attach a maintenance unit with an oiler to the compressor.
♦ Install a fitted oiler into the compressed air line or the compressor.
♦ Manually add 3–5 drops of pneumatic oil from the supplied oil
container
operation.
♦ When opening the oil container
cap nut from the container. Use a pair of long-nosed pliers or
similar implement to remove the internal pipette.
♦ Turn it 180 °, replace it and screw it back in place with the cap nut.
♦ Use a needle or similar tool to poke a small hole into the tip of the
pipette to release oil.

Connecting to a compressed air source

NOTE
► Before connecting the compressed air source,
–
the correct working pressure (3–6 bar) must be fully
reached
–
ensure that the trigger
♦ Remove the cover
♦ To seal the thread on the connecting nipple
of the sealing tape
screw the connecting nipple
│ GB │ IE
■ 36
into the connecting nipple
from the compressed air supply
around it. Use the assembly spanner
every 15 minutes of
for the first time, remove the
is not pulled
, wrap 2 or 3 layers
into the compressed air supply
.
to
PDBNP 14 A1
.