Idiomas disponibles
Idiomas disponibles
USE
1. Make access to the injector in question and remove it.
2. Select the appropriate reamer and attach it to the guide using the Allen key provided.
3. Place the reamer into the injector bay and gently rotate it clockwise while applying light pressure
and little force.
4. Use a small amount of lubricant while performing the milling operation to prevent the cutter from
"chattering" and to maintain a clean and smooth surface.
5. Do not remove too much material during milling. Remove only enough material to get a good
surface.
6. Clean the milled seal seats and remove all dirt and chips.
NOTES
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
