Idiomas disponibles
Idiomas disponibles
required during hammer work efficiency is low. Open
the grease box lid at the top of the hammer using the pin
spanner provided. Then refill approx 30g grease provided
with your tool. The grease specification is general purpose
lithium based.
Caution: Keep the container of grease
away from children.
8. OVERLOAD PROTECTION
If the tool insert becomes caught or jammed, the drive to the
drill spindle is interrupted. Because of the forces that occur,
always hold the power tool firmly with both hands and
provide for a secure stance.
WORKING HINTS FOR
YOUR TOOL
● Reduce the pressure on the drill bit when it is about to
break through. This will prevent the drill from jamming.
● When drilling a large hole, first drill a pilot hole using a
smaller drill bit.
● Always apply pressure to your drill bit in a straight line,
and if possible at right angles to the workpiece.
● Never change the operating mode whilst the rotary
hammer is running.
● Do not apply excessive pressure to the tool when
chiseling. Expressive force does not speed up the work.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal and
will not damage your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
14
TROUBLESHOOTING
1. If your power tool does not start, check the plug on the
power supply first.
2. If your hammer becomes too hot in use, set the hammer
switch to the drill mode and allow your drill to operate at
maximum speed without load for 2 minutes.
3. If your hammer work efficiency is too low, please add
sufficient grease in the grease box.
4. If work efficiency is too low please check drill bit or
chisel and make sure it is not blunt or worn.
5. If a fault cannot be rectified, return the tool to an
authorized dealer for repair.
EN
