Idiomas disponibles
Idiomas disponibles
FAULTS AND THE AFTER-SALES SERVICE
Malfunctions often have simple explanations. Please read the following notes before calling the aftersales
service.
Fault
The door panel steams up when
the oven is hot.
The flame (oven) does not burn
through all outlet openings.
The appliance does not work.
All dishes that are prepared in
the oven become burnt very
quickly.
The oven lighting has failed.
Repairs may only be carried out by fully trained after-sales service engineers.If your appliance is not repaired
professionally, you may be exposing yourself to substantial risks.
Replacing the oven light bulb
If the oven light bulb fails, it must be replaced. Replacement heat-resistant bulbs can be obtained from the
after-sales service or from specialist retailers. Please specify the SN number of your appliance.
Do not use any other type of bulb.
Proceed as follows:
1. Switch off the relevant circuit breaker.
2. Open the appliance door.
3. Lay a tea towel in the cooking compartment if it is cold to prevent damage.
4. Unscrew the glass cover from the bulb inside the cooking compartment by
turning it anti-clockwise.
5. Replace the bulb with one of the same type.
Voltage: 230V~
Temperature resistance: 300°C
6. Screw on the glass cover again.
7. Remove the tea towel and switch the circuit breaker back on. Press the
function button the oven lighting until it locks into place in order to check
whether the oven lighting is working properly.
Possible cause
Normal occurrence;
caused by the
difference in
temperature.
Normal build-up of dirt
Defective circuit
breaker
Power cut
Thermostat faulty
Oven light is faulty
Power: 25 W
English-20
Remedial action
Not possible; this has no
effect on oven performance.
The burner must be
professionally cleaned.
Look in the fuse box and
check that the circuit breaker
for the appliance is in
working order.
Check whether the kitchen
light works, for example.
Call the after-sales service.
Replace the oven light.
(see section "Replacing
oven light")
