Idiomas disponibles
Idiomas disponibles
When you route the mains cable, make sure that:
• the cable is not trapped or squashed.
• the cable does not come into contact with sharp edges or cutting edges.
• the cable does not come into contact with parts that can reach temperatures of more than 50 °C above room
temperature.
Connecting the mains cable
Where the appliance is directly connected to the power supply, an all-pole isolating switch with a
contact gap is required. Complete disconnection in compliance with the conditions specified in overvoltage
category Ill must be guaranteed. The earth cable is excluded from this.
Replacing the mains cable
The mains cable is replaced via the rear backboard.
The mains cable must be of the following type:
For 220-240V~ Modes:
• H05RR-F, H05RN-F, H07RR-F, H07RN-F. H05VV-F
• 3 x 0.75 mm2; 3 x 1.00 mm2; 3 x 1.5 mm2
Leave the mains cable slightly overlong SO that you can pull out the appliance for cleaning purposes.
Proceed as follows:
• Remove the rear backboard.
• Undo the screw on the terminal block that fixes the cable in place.
• Loosen the screw contacts and replace the cable with a new one of the same length.
• The cable must comply with the stipulated specifications.
• Connect the yellow-green wire to the < terminal.
• This wire must be at least 10 mm longer than the other wires.
• Connect the blue neutral wire to terminal N.
• Connect the brown power wire to terminal L.
The appliance must be connected in accordance with the currently applicable regula-
tions.
Before installing the appliance, check that the local conditions (type of gas and pressu-
re) are compatible with the appliance settings. The permissible appliance settings can
be found on the rating plate.
Connection to the gas lines and seal fitting must be carried out professionally according
to the currently applicable standards.
GAS CONNECTION
En g li s h- 4
