Main Component Parts; Select Push-Buttos; Led Indicators - Schulz AIR Plus Manual De Instrucciones

6. MAIN COMPONENT PARTS

12Vdc output
Display
enabled indicator
FIGURE 6.1 - SMART BATTERY CHARGER
The battery charger is composed of: seis LEDs indicadores and four select and start push buttons. When the
select push button is pressed, a beep is sounded.

Select push-buttos:

1. On/Off: Keep it pressed for one second and the charger will turn on. The display will flash "000" (standby
mode). If this button is pressed for one second during the operation, the charger will finish any operation mode
in which the charge is and turn off.
2. 2/6/12 AMP Select: Toggles the charging rate between 2A , 6A ,12A and standby mode. The display will
change each time the push-button is pressed, and the charger will start to operate in the mode chosen one second
after the last touch.
3. Battery Voltage: Press this button in the standby mode or in the charging mode. The display will indicate the
battery voltage for three seconds.
4. 12V DC Supply: Press this push-button in the standby mode ("000" flashing) so as to activate the 12Vdc
output. To turn off, press the button again.

Led Indicators:

1. AMP: This light will turn on when the charger is charging or the 12-Vdc output is activated.
2. Volt: This light will turn on when the option voltage in the battery is selected in the standby or charging mode.
3. Fault: This light will turn on when any operation fault occurs.
4. Charging: This light will turn on when the charger is charging the battery.
5. Charged: This light will turn on when the battery is charged. The indicator on the right side of the 12-Vdc
output will turn on when the output is activated.
28