Parkside PDS 30 A1 Instrucciones De Uso página 7

Parts and operating components
(See fold-out page for illustrations)
The ceiling prop PDS 30 A1 consists of the following parts:
▯ Rubber pad
▯ Upper bar
▯ Pump lever
▯ Lower bar
▯ Locking screw
▯ Tube
▯ Locking bolt
▯ Locking lever
Usage
♦ Loosen the locking screw
♦ If necessary, press the two locking bolts
pull the lower bar
is located under the load to be supported (Fig. C).
♦ Allow the two locking bolts
Use the red line which marks the position of the locking bolts
on the lower bar
♦ If the length of the lower bar
upwards (Fig. E) and pull the upper bar
♦ Re-tighten the locking screw
♦ To make fine adjustments to the height, press the pump lever
until the rubber pad
(Fig. G).
♦ To loosen and remove the prop, press the locking lever
upper bar
♦ Loosen the locking screw
♦ Hold the tube
out of their detent (Fig. B).
♦ Push the lower bar
■ 4 │ GB │ IE
1
2
3
4
5
6
7
8
5
4
out up to the required height until the rubber pad
4
as an orientation aid.
1
is located firmly under the load to be supported
2
has been completely retracted (Fig. H).
5
6
firmly with one hand and press the engaged locking bolts
4
back inside completely.
(Fig. A).
7
out of their detent (Fig. B) and
7
to engage completely in the tube
4
is insufficient, push the locking lever
2
out to the required height.
5
(Fig. F).
(Fig. A).
1
6
detent.
7
(Fig. D)
8
3
several times
8
upwards until the
7
PDS 30 A1