Idiomas disponibles
Idiomas disponibles
WARNING: Switch off and remove the battery prior to any troubleshooting.
Fault
Appliance runs slowly.
Automatic line feed does
not work.
A utomatic line feed still
does not work or the
spool is jammed.
15. ENVIRONMENTALLY FRIENDLY DISPOSAL
According to EU directive 2012/19/EU on electric and electronic equipment and its implementation
into national law, all electric tools must be separately collected and environmentally friendly recy-
cled. Alternative disposal: If the owner of the power tool does not return the tool to the manufactu-
rer, he is responsible for proper disposal at a designated collection point that prepares the device
for recycling according to national recycling laws and regulations. This does not include accessories
and tools without electric or electronic components.
Accumulator Disposal:
Old Accumulators and batteries must not be added to household waste, but should be disposed of
in accordance with the applicable legislation.
- Take unusable rechargeable batteries to the dealer's or community's battery collection point.
Disposing of the packaging:
The packaging is made of cardboard and separately labeled foil which is also recyclable.
- Take these materials to a recycling centre.
Battery packs/batteries:
Li-lon
Do not dispose of batteries into household waste, water or fire. Battery packs/batteries must
be collected, recycled or disposed of in an environmentally -friendly way.
Only for EC countries:
Defective or dead batteries must be recycled according to the directive 91/157/EC
Remedial action
Recharge battery.
Check that the spool housing can rotate freely. Carefully
clean it if necessary.
1. Keep the tabs depressed and remove the spool cover
from the housing.
2. Pull the cutting line until it protrudes 11 cm from the
housing. If insufficient cutting line is left on the spool, install
a new spool of cutting line as instructed above.
3. Align the tabs on the spool cover with the cut outs in the
housing.
4. Push the cover onto the housing until it snaps securely
into place.
5. If the cutting line protrudes beyond the trimming blade, cut
it off so that it just reaches the blade.
1. Carefully clean the spool cover and housing.
2. Remove the spool and check if the lever can move freely.
3. Remove the spool and unwind the cutting line, then wind it
on neatly again as described above. Replace the spool as
instr ucted.
13
