cecotec READYWARM 9600 SMART FORCE Manual De Instrucciones página 28

ENGLISH
Display
Fig. 3
1. Oscillation
2. Automatic mode
3. Low heating power
4. High heating power
5. Frost protection mode
6. Timer
7. Room temperature
8. Selectable temperature
Switching ON/OFF the device
1. Insert the power plug into the wall socket.
2. Turn the power switch on (I) to turn the device on. The power switch and the display will
light up, indicating the device has entered the standby mode.
3. Press the On/Off button to enter the operating modes option. The light indicator will turn
on.
4. Press the standby button to switch back to standby mode once operation is over.
5. Turn the power switch off (0) to switch the device completely off.
Setting modes
Press this button repeatedly to select the desired operation mode.
Fig. 4 Low heating power (1000 W).
Fig. 5 High heating power (2000 W).
Fig. 6 Automatic mode: The device adapts heating power to the room temperature.
Fig. 7 Frost protection: The device turns automatically on when the room temperature
is below 6 ºC.
Temperature setting
- The desired temperature is shown on the display (above the room temperature).
- Use the + and - buttons to increase the desired temperature up to 38 ºC and to decrease
it down to 6 ºC.
- The room temperature is measured by the temperature sensor and shown on the display.
- The device includes a thermostat that automatically switches off the device when the
room temperature has reached the desired one. If the room temperature falls below the
set one, the device will switch automatically on again.
READYWARM 9600 SMART FORCE
28