Taurus 920800 Manual De Instrucciones página 6

920800_IM.pdf
the pressure (Control knob (B) on OFF position (L) and
machine cooled.
Pour the frothy milk into the prepared espresso, now the
cappuccino is ready.
Sweeten to taste and, if desired, sprinkle the foam with a
little cocoa powder.
Note: We recommend that you allow the appliance to
cool down before making coffee again. Otherwise, as
temperature is too hot, a burning smell may occur in your
espresso.
ance:
Turn the appliance off, ensuring we are in the OFF
position.
Unplug the appliance from the mains.
Wait for it to cool down to remove the Safety Cap (A)
Remove the water from the water tank.
Clean the appliance.
C
M CLEANING
Y
Disconnect the appliance from the mains and allow it to
CM cool before undertaking any cleaning task.
Clean the equipment with a damp cloth with a few drops
MY
of washing-up liquid and then dry.
CY
Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
CMY
appliance.
K
Do not let water or any other liquid get into the air vents
Symptom
side of the holder
The steam cannot froth.
6 2022/07/18 11:25
-
Possible cause
The Edge of the sieve is covered
coffee.
The brewing set is dirty.
The steam ready indicator (green
indicator) is not illuminated.
The container is too big or the shape
You have used skimmed milk
to avoid damage to the inner parts of the appliance.
No parts of this appliance are suitable for cleaning in the
dishwasher.
Then dry all parts before its assembly and storage.
How to deal with lime scale incrustations:
For the appliance to work correctly it should be kept free
of limescale or magnesium incrustations caused by the
use of hard water.
To prevent this kind of problem, we recommend the use
of water with low lime or magnesium mineralisation.
However, if it is not possible to use the kind of water
recommended above, you should periodically remove
the limescale from the appliance:
Every 6 weeks if the water is "very hard".
Every 12 weeks if the water is "hard".
this kind of product for sale in specialized stores and
authorized technical services
Homemade solutions are not recommended in the des-
caling of this appliance, such as the use of vinegar.
ANOMALIES AND REPAIR
Take the appliance to an authorised technical support
service if product is damaged or other problems arise.
Do not attempt to disassemble or repair the appliance
yourself as this may be dangerous.
If you detect any anomalies, refer to the following table:
Solutions
Clean the sieve around the edge and clean
the brewing of coffee set
Clean With a damp cloth.
Only after the steam ready indicator (green
indicator) is illuminated, the steam can be
used to froth.
Use high and narrow cup.
Use whole milk or half-skimmed milk