Troubleshooting - Sears Kenmore 2600 010 Serie Manual De Uso Y Cuidado

if you experience
TROUBLESHOOTING
First try the solutions suggested here
for assistance and to possibly avoid a service call.
Possible Causes
Check the following for Feet may not be in contact with the
proper installation or floor and locked.
see "Using Your
Washer" section.
Washer may not be level.
Clicking or metallic
noises
Gurgling or humming
Humming
Check the following for
proper installation:
Not enough water
in washer
Washer won't run or
fill, washer stops
working or wash light
remains on (indicating
that the washer was
unable to fill
_ppropriately)
Load could be unbalanced.
Objects caught in washer drain
system.
Washer may be draining water.
The sensing light is on.
Washer not level.
Fill hoses not attached tightly.
Fill hose washers.
Drain hose connection.
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded properly.
Load not completely covered
in water.
Check for proper water supply.
SoJutlon
Front and rear feet must be in firm contact with floor, and
washer must be level to operate properly. Jam nuts must be tight
against the bottom of the cabinet.
Check floor for flexing or sagging, if flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in installation instructions.
Load garments in loose heaps evenly around the washplate. Do not
load garments directly over the center of the washplate. Adding wet items
to washer or adding more water to basket could unbalance washer.
Wash smaller loads to reduce imbalance.
Use Bulky cycle for oversized, non-absorbent items such as
small comforters or poly-fllled jackets.
See "Cycle Guide" and "Washer Care'.i
Empty pockets before washing. Loose items such as coins
could fail between basket and tub or may block pump.
it may be necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
It is normal to hear the pump making a continuous humming
sound with periodic gurgling or surging as final amounts of water
are removed during the Spin/Drain cycles.
You may hear the hum of the sensing spins after you have started
the washer. This is normal. Sensing spins wJlJ take several minutes
before water is added to the washer.
Water may splash off basket if washer is not level.
Tighten fill-hose connection.
Make sure all four flJJ hose flat washers are properly seated.
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Water can back up out of a clogged sink or drainpipe. Check
all household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets.)
Unbalanced loading can cause basket to be out of alignment
and cause water to splash off tub. See "Using Your Washer"
for loading instructions.
This is normal operation for an HE low-water washer. The load will
not be completely underwater. The washer senses load sizes and
adds correct amount of water for optimal cleaning. See "What's
New under the Lid."
iMPORTANT: Do not add more water to washer. The added water
lifts the load off the washpiate, resulting in less effective cleaning.
Both hoses must be attached and have water flowing to
inlet valve.
Both Hot and Cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
J
13