Idiomas disponibles
Idiomas disponibles
NOTE: Do not plug your extension cord into the power source recep-
tacle (outlet) prior to routing it through the cord retainer and connecting
the extension cord to the mower's cord outlet receptacle.
To properly route your extension cord through the cord retainer:
1.
Approximately 14 to 16-inches from its end, crease your extension
cord to form a tight loop.
2.
Push the loop through the bottom hole in the cord retainer. See
Figure 4-A.
3.
Position the loop over the clip found on the cord retainer and pull
down until the cord fits snugly into the clip. See Figure 4-B.
a
b
NOTE: Use a UL-approved extension cord. A 100-foot, 14-gauge cord
is recommended. A 50-foot, 16-gauge cord is acceptable. Refer to the
small chart found in Safe Operation Practices.
The cord retainer and the guide bar work together to secure your
extension cord and safely limit its movement. The cord retainer (with
the extension cord) will slide along the guide bar as the mower is
moved to the left or to the right.
Figure 4
ASSEMBLY
GraSS CaTCher
1.
Follow steps below to assemble the grass catcher (if needed).
Make certain bag is turned right side out before assembling
(warning label will be on the outside).
a.
Place bag over frame so that its black plastic side is at the
bottom.
b.
Slip plastic channel of grass bag over frame rods. See Figure
5. All the plastic channels except center top of bag attach
from outside of bag.
c.
Attach center top of bag from inside of bag.
11
A
C
B
Figure 5
