Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1)
Turn off power to outlet.
2)
This device shall be mounted at a sufficient height from grade such that the height of the
storage means for the coupling device is located between 600 mm (24 inches) and 1.2 m
(4 feet) from grade.
3)
Locate power outlet and mount unit within reach of the power cord. It is recommended that
at least two of the mounting screws fasten into a wall stud, plywood or other material
capable of supporting the charger..
4)
Utilize the mounting plate as a hole guide and drill holes 3/8" diameter to a depth of 2" for
holes in drywall or masonry.
5)
Insert the plastic anchors into the holes and then mount the plate using the included
screws.
6)
If the desired location of the connector holster and cable hook is right below the charger
hang it on the bottom of the mounting plate and use at least one screw to hold it in place.
7)
If the desired location of the connector holster and cable hook is to the side of the charger
use the included anchors and screws to mount with a least two of the mounting hold in
material capable of supporting the cable.
8)
Remove the small back cover on the back of the charger and set the Amperage of the
charger to a maximum of the allowable charger amp for the circuit breaker on the circuit.
Replace the small cover.
9)
Align the top rear notch of charger into the wall-mounted bracket and the insert the two
screws into the bottom of the charger through the holes in the bottom of the mounting
plate.
10) Hang cable on hook and place connector into holster
11) It is recommended that the circuit breaker be non-GFCI since the charger has that
protection and GFCI breakers can cause nuisance tripping
12) Plug charger into NEMA 14-50 receptacle with 200-240V and turn on power
Charger
Mounting
Plate
www.breez-EV.com 847-380-3540
Cable Hook
Connector
Holster
Anchors
Mounting
Screws
and
5
