Chicco Sprint Instrucciones De Uso página 13

fabric where the baby's feet will lie (diagram
5A). Fasten the cover in place using the two
side snap-buttons (diagram 5B) and insert
the eyelet over the relative hook where the
baby's feet will lie (diagram 5C). To guarantee
additional protection for your baby, thread
the two tape fasteners through the slots and
close the snap-buttons inside the hood, as
seen in diagram 5D.
The carrycot apron can be transformed into a
legcover for the stroller. Refer to the instruction
manual of the stroller for details related to assem-
bly of the legcover configuration.
ADJUSTABLE BACKREST -
COMFORT SYSTEM
6- The backrest of the carrycot can be adjusted
gradually. To lift or lower the backrest use the
wheel located on the outer part of the carrycot
near the baby's feet (figure 6).
WARNING: It is advisable to ventilate the carrycot
after prolonged use.
CARRYING HANDLE
7- The carrycot comes with a comfortable carry-
ing handle that can be adjusted in three posi-
tions (fig. 7):
A) Transport
B) Middle
C) Rest
8- To put the handle in the vertical position, grasp
it in the centre and pull it upwards until you
hear a click (figure 8 A); to put the handle back
in the rest position press both buttons at the
base of the handle at the same time and then
turn it downwards (figure 8 B).
WARNING: Do not transport the carrycot with the
handle in the middle or rest position, but only
with the handle in carrying position.
WASHING
The hood, internal lining of the carrycot, and mat-
tress are removable and may be washed; it is ad-
vised to carefully follow the washing instructions
shown on the item's label.
9- Remove the hood of the carrycot following the
instructions in point 3; then release the two
press studs that fasten the metal arch to the
fabric, and only pull out the metal arch by
pulling it from one of the two ends (figure 9);
do not pull out the rear arch with the 4 tabs
All manuals and user guides at all-guides.com
for washing.
10- Remove the mattress padding through the
opening located on the back of the cover
(figure 10).
11- To remove the carrycot internal lining, pull
the plastic strip, positioned where the baby's
head will lie, and slide it off the carrycot
(diag. 11).
The washing symbols and their significance are
as follows:
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
USING THE CARRYCOT AS A BABY CARRIAGE
This carrycot can be used as a baby carriage
mounted on Chicco strollers that have the "Click
Clak" system.
HOW TO ATTACH THE CARRYCOT TO THE
STROLLER
Prepare the stroller, equipped with the Clik Clak
system, to mount the carrycot as shown in the
instructions of the specific stroller.
NB: For strollers equipped with a backrest or
removable seat, it is advisable to unhook the
backrest or seat as shown in the specific stroller
instructions sheet.
12- Grip the carrying handle in the transport posi-
tion and place the carrycot on the arms. The
baby's feet end of the carrycot should be clos-
est to the stroller's handle (figure 12).
13- Align the pins on the two sides of the carrycot
with the openings located on the arms of the
stroller (figure 13 A), then carefully set down
the carrycot until you hear the lock click (fig-
ure 13 B).
WARNING: Before using, make sure that the carry-
cot is properly locked on by pulling on it upwards.
REMOVING THE CARRYCOT
14- Bring the handle to its vertical position (trans-
port mode) until you hear a click which means
it is locked in place (figure 14).
13