Checking/Replacing Battery Of Remote Control - EYENIMAL RT 350 Manual De Instrucciones

IMPORTANT: before beginning the coding, make sure no other person is using his 350 REMOTE TRAINER or other products from the
EYENIMAL range close by: your receiver collar could accidentally record the code of his remote control. If that occurs, re-code the remote
control with the receiver collar.
CODING PROCEDURE
1. Activate the remote control: press for 1 second the On/Off red button
2. Collar in position "deactivated" (indicator light off): move the remote control towards the collar so that the red mark on the remote
control comes into contact with the red mark on the receiver, hold for 6 seconds. The indicator on the collar lights in fixed green, then
flashes in red.
3. Move the remote control away from the receiver collar.
4. Press the button of the remote control. A beep sound is emitted; the collar is then synchronized with your remote control.
 Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new one from EYENIMAL range (Ref. § Coding
procedure).
● How to use the remote control
The 350 REMOTE TRAINER remote control is designed to operate with 1 receiver collar.

button: beeper
If you press the Beeper button, the receiver collar will emit sound signals. There is no time limit for this function: the beeper will continue to
sound for as long as the button is pressed.
It's up to you to use the beeper depending on the way you want to train your dog. With the beeper you can:
 send a sound to your dog when it is disobedient,
 draw its attention...
It's very important to always use the beeper in the same way in order not to disturb your dog.
 F button: Flash static correction
Press the F button to send a warning to your dog using static correction transmitted by the two contact points located on the receiver collar for
a defined length of time of less than one second.
 C button: Continuous static correction
Press the C button to send a warning to your dog using static corrections transmitted by the two contact points located on the receiver collar,
this will last for as long as the button is pressed but limited to 8 seconds maximum.
 "+" and "-": static correction level control buttons
Use the "+/-" buttons for rapid adjustment of the static correction level of the receiver collar.
9 levels are available.
1: very weak static correction – Level 9: strong static correction
Level
Always start with the lowest level of static correction.
● Checking/replacing battery of remote control
Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be prepared to replace the battery.
To check the condition of the battery, turn on the remote control and look at the battery level indicator on the LCD screen. The symbols which
appear indicate the following:
located on the side of the remote control.
- 3 -