ments are made. This is a result of the cooling process, which must
take place for the IR sensor.
7
Data Logger
7.1 Storing Data
Your thermometer is capable of storing up to 20 data locations.
The infrared temperature and temperature scale (
stored.
To store data from an infrared reading, pull the trigger. While
holding the trigger, press the MODE button until LOG appears in
the lower left corner of the display; a log location number will be
shown. If no temperature has been recorded in the shown LOG lo-
cation, 4 dashes will appear in the lower right corner. Aim the unit at
the target area you want to record, and press the laser/backlight
button. The recorded temperature will appear in the lower right cor-
ner. To select another log location, press the up and down keys.
7.2 Recalling Data
To recall stored data after the unit shuts off, press the MODE
button until LOG appears in the lower left corner. A LOG location
number will be shown below LOG, and the stored temperature for
that location will be display. To move to another LOG location,
press the UP and DOWN keys.
7.3 Log Clear Function
The "Log clear" function allows you to quickly clear all logged
data points. This function can only be used when the unit is in LOG
mode. It can be used when the user has any number of LOG loca-
tions stored.
You should only use the LOG clear function if you want to clear
all the Log location data that is stored in unit's memory. The "LOG
clear" function works as follows:
(1) While in LOG mode, press the Trigger, and then press the
DOWN button until you reach LOG location "0".
DIT-130 – USER MANUAL
o
o
C or
F) are also
37