Idiomas disponibles
Idiomas disponibles
ENGLISH
1.
Firmly insert power cord connector (with TOP
shown facing up) until you hear a "click".
NOTE: The "click" indicates the power cord is connected
correctly.
Figure 1.
Connect Power Cable
2.
To disconnect, firmly grip the power cord
connector on each side, press the two tabs,
and pull out.
Figure 2.
Disconnect Power Cable
Page 6
"Click"
Polaris
Section 4. General Cleaner
Operation
CAUTION
To prevent damage to the cleaner, to adhere to the following
guidelines:
• Remove the cleaner from the pool after the cleaning cycle is
completed.
• Store out of direct sunlight or inclement weather.
• Never lift the cleaner out of the pool by the floating cable.
• Take additional care when lifting the cleaner out of the pool.
It becomes heavier when filled with water.
• Always remove the cleaner from pool when super chlorinating or
adding acid.
• Do not handle cleaner while it is in operation.
IMPORTANT
• Always fully submerge the cleaner head before you begin operation.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a permanent basis.
• At the end of each cycle, remove the cleaner from the pool.
• Start at the cleaner head and untangle any coils in the cable before
storing the cleaner.
The robotic cleaner includes a safety feature that
automatically stops the cleaner if a cleaning cycle
starts but it is not submerged in water. For pools
equipped with a beach area, this safety feature is
programmed to drive the cleaner in reverse and back
into the pool when the impeller is out of the water.
4.1
Install and Submerge the Cleaner
1.
With the control box plugged into a power
outlet, spread the floating cable across the
pool deck until you reach the middle of the
pool length.
WARNING
Do not use an extension cord.
2.
At the center point, submerge the cleaner in the
pool and hold in the vertical position to release
any air trapped inside.
Robotic Pool Cleaner | Owner's Manual
®
