Hayward 3429LEDBL Manual Del Usuario página 9

EN
USE
Autonomous Mode (RGB colour light only)
In the absence of an RC box, the lights work autonomously and the user can choose between 18 modes: 11 fixed colours
and 7 automatic colour change sequences (see the sequences box below).
Sequence
1
2
3
4
5
6
7
8
9
*: Possible customisable sequence using and connecting the control centre.
Colour change can be obtained by cutting power to the lights for a very short time (<1s).
By successive interruptions, it is possible to scroll through the 18 operating modes. After mode 18, the lights return to the
first automatic sequence (mode 1).
To synchronise the lights bringing them simultaneously to mode 2, it is advisable to cut the power for about 2s.
When the light is switched on after a stop of several seconds (>4s), it turns on in White for 15s, and then returns to the mode
used the last time it was on; this allows for maximum lighting in case it accidentally falls into light-source support.
Safety (RGB colour light only)
In the event of an abnormal increase in temperature inside the bulb, a safety device prevents the bulb from lighting, and it
emits red flashes. As soon as the temperature returns to normal, the bulb resumes normal operation.
If a voltage that is too low (<11V) or too high (>15V) is detected, the bulb will cease to function and will emit green
flashes. To return to normal operation, it is essential to cut off the power to the lights.
MAINTENANCE
When replacing parts, always use original spares.
The bulb should be changed outside the water.
Changing of the light source contained in this light fitting should only be carried out by the manufacturer or its service agent,
or an equivalently qualified person.
When changing the bulb and/or the cable, it is recommended to change all the parts that ensure the seals are watertight.
When changing the bulb, the gasket and sealing elements must also be changed. Ensure they are correctly assembled.
In the event of malfunction, it will be necessary to change the entire LED bulb. Never open it or attempt to repair it.
To avoid accidents, if the power cable or cable sheath is damaged, it must be changed by the manufacturer, at an Authorised
Service Centre or by a qualified technician.
The cable must meet the following mechanical and electrical requirements: H05RN-F with a minimum section of 2x1.5mm 2 .
DISPOSAL OF BULBS AND REMOTE CONTROLS
AT THE END OF THEIR USEFUL LIFE:
The symbol, a rubbish bin with a line below it, indicates the need for specific collection of electrical or electronic devices. This
implies that these devices and their waste must not be disposed of together with household waste, but must be deposited at
a specific collection point. If you require further information, contact your local town hall, or the distributor where you bought
the product. The correct disposal of electrical and electronic devices helps prevent possible damage to the environment and
human health, and helps preserve natural resources.
Colour/Program
Colour: White
Colour: Blue
Colour: Lagoon blue
Colour: Cyan
Colour: Purple
Colour: Magenta
Colour: Rose coloured
Colour: Red
Colour: Orange
Only use Hayward ® replacement parts
Sequence Colour/Program
10 Colour: Green
11* Colour: Emerald green
12 Program: Quick colour alternation
13 Program: Slow colour alternation
14 Program: 11 fixed colours
15 Program: Psychedelic
16 Program: Blue/Cyan/White
17 Program: Random colours 1
18 Program: Random colours 2
9
Rev. C