GYS POT COMBI ARCPULL Manual De Instrucciones página 38

Operating manual
ADJUSTING A STUD HOLDER - INSULATION NAILS
Adjustment
screw
1) Unscrew the locking nut on the stud holder adjusting spindle.
2) Insert the attachment into the stud holder and adjust the screw so that the end of the attachment protrudes 5 mm
from it..
3) Screw on the locking nut.
Note: If the weld of the insert shows marks of the stud holder at
the weld, adjust the stud holder screw so that the insert
extends a little further
from the stud holder.
Installation of the earth rods pad and the protective gas cover:
• Insert the gas protection cap into the grounding pad and lock it with
the screw.
It is essential that the cap is placed on the other side of the pusher pad.
The gas shielding cover must not be mounted on the grounding pad when welding without any gas
shielding.
• Put the pad (fitted with the cover) at the end of the ground rods and
screw in the 2 clamping screws. It is recommended to place the pad
with the clamping screws pointing down to the bottom of the gun to
keep the positioning markings clearly visible.
Note: The use of gas protection and grounding pad is not necessary
when welding a pulling ring.
38
Original manual
Lock-
nut
Markings
GYSPOT COMBI ARCPULL
5 mm
Protective gas cover
Push buttons
Location
markings
Clamping screw
Grip pad
for earth