Idiomas disponibles
Idiomas disponibles
PROGRAMMING THE FIRST TRANSMITTER
5
This operation can only be performed from the transmitter that was used for operation 4.1.
- Press the transmitter PROG Key for approximately
1 second. The motor will jog.
Your transmitter is now programmed to control the
motor in stable mode.
PROGRAMMING/ADDING A NEW (INDIVIDUAL, GROUP, OR MASTER) TRANSMITTER/CHANNEL
6
6.1- Open the memory of the motor using the
programmed transmitter:
- Press the PROG key of the transmitter for about 3
seconds until the motor jogs.
6.2- Confirm the new transmitter you wish to add:
- Press the PROG key of the new transmitter/channel less
than 1 second. The motor will jog.
- For group controls, repeat operations 6.1 and 6.2 for each
motor in the group.
- For general controls, repeat operations 6.1 and 6.2 for
each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations 6.1 with a programmed transmitter, then
perform the operation 6.2 with the transmitter to be deleted.
PROGRAMMING A SENSOR
7
7.1- Open the memory of the motor using a programmed
transmitter:
- Press the PROG key of the transmitter for about 3
seconds until the motor jogs.
7.2- Confirm the sensor you wish to add:
- Press the PROG key of the sensor less than 1 second.
The motor will jog.
- For group controls, repeat operations 7.1 and 7.2 for each
motor in the sensor group.
- To delete a sensor from the memory of a motor perform operations 7.1 with a programmed transmitter, then
perform the operation 7.2 with the sensor to be deleted.
Recommendations when using a sensor: If the Wind sensor on an installation is changed or deleted, it is
important to delete it from the memory of all the motors in which it was programmed.
1
PROG 1 s
1
PROG ≥ 3 s
2
PROG < 1 s
1
PROG ≥ 3 s
2
PROG < 1 s
US
7/12
