Idiomas disponibles
Idiomas disponibles
SETTING 4: MANUALLY SETTING THE DOWN END LIMIT WITH AUTOMATIC BOTTOM LOCK SYSTEM
AND AUTOMATICLY SETTING THE UP END LIMIT (Product without automatic locking system prohibited):
The locking system at the lower end limit may vary depending on the product, but the procedure for setting
the entrance/exit positions of the latches remains the same on all systems.
1
5 s
1- Press simultaneously for 5 seconds the « UP » and « DOWN » buttons: the motor will jog once normally and
then a second time with a slow jog.
2- Press the « DOWN » button: the motor will run down. Then press the « STOP » button to stop the product at
position (P1), which corresponds to the automatic locking system's entrance point (the fabric should not be
tense).
3- If necessary adjust the position with the « UP » and « DOWN » buttons.
4- Press simultaneously on the « STOP » and « UP » buttons: the motor runs up and stop, putting tension on the
fabric.
5- Press the « DOWN » button: the motor will run down. Press the « STOP » button to stop the motor at position
(P2), which corresponds to the automatic locking system's exit point.
6- Press 2 s on the « STOP » button to confirm the adjustments, the motor jogs.
The operation is completed. Go to section §5.
2
P1
+
5
P2
+
3
1
P
2
P
6
1
P
2
P
2 s
4
1
P
2
P
US
5/12
