Idiomas disponibles
Idiomas disponibles
Problem
Some pans make
crackling or clicking
noises.
The induction hob
makes a low humming
noise when used on a
high heat setting.
Fan noise coming from
the induction hob.
Pan does not heat up
and it does not appear
in the display.
Error Code
Error Message
ER03
Water or pan on the Control Panel.
E1
Hob has overheated.
E2
Hob has overheated.
E3
Abnormal power supply detected (too high).
E4
Abnormal power supply detected (too low).
E5.
Temperature sensor failure and the
defective cooking zone will display an 'E'.
F1, F3, F4.
Hardware failure.
If the Control Panel overheats it will change colour and
sound an audible alarm.
This appliance respects laws of the suppression of radio interference. As the Manufacturer has a policy of
continuous product improvement, it reserves the right to adapt and carry out any modification considered
necessary without prior warning.
Kingfisher International Products B.V., Rapenburgerstraat 175E, 1011 VM Amsterdam, The Netherlands.
Kingisher International Products Limited, 3 Sheldon Square, London, W2 6PX, United Kingdom
5059340445816_MNL_IN_V02.indb 97
5059340445816_MNL_IN_V02.indb 97
Possible cause
This may be caused by the
construction of your cookware (layers
of different metals vibrating differently).
This is caused by the technology of
induction cooking.
A cooling fan built into your induction
hob has come on to prevent the
electronics from overheating. It may
continue to run even after you've
turned the induction hob off.
The induction hob cannot detect the
pan because it is not suitable for
induction cooking. The induction hob
cannot detect the pan because it is
too small for the cooking zone or not
properly centred on it.
Solution
This is normal for cookware and does
not indicate a fault.
This is normal, but the noise should
quieten down or disappear completely
when you decrease the heat setting.
This is normal and needs no action.
Do not switch the power to the
induction hob off at the consumer unit
when the fan is operating.
Use cookware suitable for induction
cooking. Centre the pan and make
sure that its base matches the size of
the cooking zone. (See the Cookware
section).
Solution
Clean the Control Panel or move the pan.
Allow to cool and restart after 30 minutes.
Allow to cool and restart after 30 minutes.
Ensure the correct power supply is
being used.
Ensure the correct power supply is
being used.
Contact Customer Services.
Contact Customer Services.
Allow to cool and restart after 30 minutes.
97
20-06-2022 13:11:39
20-06-2022 13:11:39
