Idiomas disponibles
Idiomas disponibles
39
5. Once the device has reached the correct temperature, the control lamp STEAM / HOT
WATER lights up constantly, the device starts to emit steam and any existing condensation is
drained away.
6. Turn the steam power control to the
the steam nozzle.
7. Pour milk at fridge temperature with a fat content of at least 2% to a level of roughly two-
thirds into the small milk jug for frothing.
8. Direct the steam nozzle into the small milk jug and immerse it in the milk.
9. Start the frothing process by gradually turning the steam power control to the
10. First hold the steam nozzle just below the surface of the milk to warm it up and draw air
under the milk. Once the milk is warm to the touch and a fi ne milk froth resembling a cream
is produced, hold the steam nozzle in the middle of the frothing container so that the milk is
swirled around.
11. Once the milk froth is of the desired consistency, turn the steam power control to the
position and pull the frothing container down and outwards.
12. Tap the frothing container one to two times on a solid surface to compress the milk froth.
13. Pour the milk froth into the drinking vessel or scoop it with a spoon.
14. Clean the steam nozzle after each use to prevent a blockage (see the "Cleaning and Care"
chapter – "Cleaning the Steam Nozzle").
Empty the drip tray after preparation so that it cannot overfl ow if you prepare another
drink.
15. Switch the device to sleep mode by touching the fi eld
fi eld
.
If there is no more action, the device automatically switches to sleep mode after approx.
30 minutes. All fi elds go out, apart from the fi eld
the fi eld
.
Dispensing Hot Water
1. Fill the water tank (6) (see the "Preparation" chapter – "Filling the Water Tank").
2. Direct the steam nozzle (9) towards the drip tray (13) or into an empty vessel.
Approx. 190 – 240 ml of hot water are dispensed. Make sure that the vessel is large enough!
3. Move the steam power control (8) to position
4. Switch on the device by touching the fi eld
The control lamp STEAM / HOT WATER (27) fl ashes.
5. Once the device has reached the correct temperature, the control lamp STEAM / HOT
WATER lights up constantly and the device starts to emit water.
position as soon as steam emerges continuously from
. All fi elds go out, apart from the
. To switch the device on again, touch
(Hot water).
(22). The device switches to preheating mode.
EN
position.
