Technical Data - YATO YT-85370 Manual Del Usuario

APPLIANCE CHARACTERISTICS
The hydrophore is a device which allows to supply water to places where it is not possible to install the water supply network.
The hydrophore is equipped with a pump and a water tank. The tank allows slower pump mechanism wear by reducing the pump
operation time. The pump is used to pump clean water. The pump is not designed to pump polluted water and liquids other than
water, such as oils, petrol, solvents, acids, bases, organic substances, fats, sewage, faecal matter, as well as water contaminated
with such substances. The pumped water should also not contain mechanical impurities or other abrasive particles.
Caution! The pump can be damaged as a result of stop of the water fl ow through the pump!
The correct, reliable and safe operation of the device depends on its proper use, therefore:
Read and keep the entire manual before the fi rst use of the device.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this manual.
ACCESSORIES
The hydrophore is supplied complete and does not require assembly. The equipment does not include connecting hoses, cou-
plings, valves and fi lters.

TECHNICAL DATA

Parameter
Catalogue No.
Device weight
Rated voltage
Rated frequency
Rated power Maximum pump capacity
Maximum lifting height
Maximum suction depth
Maximum water temperature
Water connection diameter
Switch-on pressure
Switch-off pressure
Protection rating
Electric insulation class
Tank capacity
Maximum air pressure
Noise level
Sound pressure L ± K
pA
Sound power L ± K
wA
SAFETY INSTRUCTIONS
CAUTION! Read all of the following instructions. Failure to do so may result in electric shock, fi re, or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
Instructions for use
The device is intended only for pumping clean water. Mechanical impurities must not be abrasive and the size of individual parti-
cles must not exceed the size given in the technical data table. The device is not designed to pump liquids other than water, such
as oils, petrol, solvents, acids, bases, organic substances, fats, sewage, faecal matter, as well as water contaminated with such
substances. The device must be kept under supervision at all times during operation. Do not allow the pump to operate dry. This
will cause the pump to overheat, which can damage it and cause fi re or electrical shock.
The pump must not be used: for pumping drinking water; for continuous operation, for example, for supplying a fountain with
water; for pumping water at a temperature higher than that specifi ed in the technical data table.
O R I G I N A L
GB
Unit
[kg]
[V~]
[Hz]
[W] [l/min.]
[m]
[m]
[ C]
O
["]
[MPa]
[MPa]
[l]
[MPa]
[dB(A)]
[dB(A)]
I N S T R U C T I O N S
Value
YT-85370
10.6
230
50
1200 4000
50
9
35
1
0.15
0.28
IPX4
I
19
0.28
69,43 ± 1,49
82,35 ± 1,49
9