Idiomas disponibles
Idiomas disponibles
1.
Using a
U-channels as shown in Fig 1 and Fig 1.1.
NOTE:
Holes should only be drilled through one wall.
2.
Lay post on side and place a pre-drilled U-channel on one
side of the post. The bottom of the post channel should be
1
⁄
" from the surface plate as shown in Fig 2 and Fig 2.1.
3
8
a. Center U-channel on post and use the holes in the
U-channel as a guide, predrill the post using a
b. Install 3 screws to attach the U-channel to the post.
c. Repeat for the other side and stand posts upright.
NOTE:
There should be two remaining pre-drilled
35¾" U-channels that will be used on the upper portion of
the vinyl panel.
⁄
" drill bit, drill holes into the four 35¾"
1
8
⁄
" drill bit.
1
8
Front View
Side View
Fig. 1
Fig. 1.1
Fig. 2
Fig. 2.1
1
⁄
"
3
1 3/
8
3
