Idiomas disponibles
Idiomas disponibles
Fax +32 030 9904733
is not recommended; if their use is indispensable, they must conform to existing safety standards and
their current capacity (amperes) must not be less that the maximum of the applian ce.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• To not place the appliance near sinks or other container of liquids (minimum distance of 2 meters) to
avoid the risk of it falling in.
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance
could upset).
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the event of a breakdown or poor operation, turn the appliance off and ask for professionally
qualified help.
ASSEMBLY
Attention: the fan can only be used if complete with the support base.
The fan can only be used if complete with the support base. To assemble it, refer to fig. assembly: first
screw on the back shell, then the front, and inset the electric cord through the guide, making sure to lock it
with the screws provided. Always unplug the appliance before you assemble.
Assembly
A. Tower fan
B.
Attachment
screws
C.
Rear shell
D. Front shell
USE
Attention: the fan can be used only when completely and correctly assembled, that is complete with its
base.
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
The fan's functions can be controlled either with the keypad located on the control panel or with the
remote control. The remote control must be pointed at the control panel; for the first use take off the tab
transparent plastic of the batteri's side (type CR2025), not included inside the box.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
Control Panel
1. Timer button
2. Speed button
3. Oscillation button
4. Mode buttom
5. On/Off button
7
20
/
Assembly page 7/20
Remote control
1.
Timer button
2.
Speed button
3.
Oscillation button
4.
Mode buttom
5.
On/Off button
