Idiomas disponibles
Idiomas disponibles
CONNECTION
- Before making any connection, make sure that all equipment is turned off. Check that the CH A and
CH B volume controls are set to a minimum.
- Connect the speakers in a series/parallel circuit so that the load impedance of the speakers equals the
output load impedance of the amplifier and the power supplied by the amplifier does not exceed the power
supported by the speakers.
- Once the connections have been made according to your needs, connect the devices to the power outlet
and turn them on. After use, do not forget to turn off and disconnect the device from the power outlet.
STEREO MODE (STEREO
Set the operating selector on the rear of the power amplifier to the STEREO position.
In this mode, the two channels operate independently. Connect both speaker inputs, both speaker outputs,
the screw terminals or the banana plugs.
The volume of both channels is adjusted separately using the controls on the front of the amplifier..
PARALLEL MODE (PARALLEL)
Set the operating selector on the rear of the power amplifier to the PARALLEL position.
In this mode, the input of the two channels will be what is set as the CH A channel input signal. Connect the
CH A input and both speaker outputs, the screw terminals or the banana plugs.
The volume of both channels is adjusted separately.
3
EN
