Idiomas disponibles
Idiomas disponibles
Tool Specifications
Orbital sander
Order number
Rated input
Orbit frequency
No-load speed
Orbit diameter
Sanding sheet:
Weight (without accessories), approx.
Protection class
Please observe the order number of your machine. The trade names of the individual machines may vary.
Machine Elements
1 Clamp
2 On/Off switch
3 Lock-on button for On/Off switch
4 Dust box (micro filtersystem)
5 Sanding plate
6 Sanding sheet*
7 Holder
8 Outlet piece
9 Latching lever
10 Filter element (micro filtersystem)
11 Extraction adapter*
12 Perforating tool*
* Not all of the accessories illustrated or described are
included as standard delivery.
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the product is 83 dB (A).
The noise level when working can exceed
85 dB (A).
Wear hearing protection!
The typically weighted acceleration is 6 m/s
Intended Use
The machine is intended for the dry sanding of
surfaces of wood, plastic and filler as well as for
painter surfaces.
7 • 2 609 932 212 • TMS • 18.03.03
PSS 150 A-C
0 603 366 2..
[W]
150
[opm]
24 000
[rpm]
12 000
[mm]
1.8
[mm]
93 x 230
[kg]
1.5
/ II
general safety notes in the enclosed booklet
must be observed.
Wear safety goggles.
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
The machine can be used only for dry sanding.
2
.
Insert the mains plug only when the machine is
switched off.
Always direct the cable to the rear away from
the machine.
Do not work with materials containing asbes-
tos.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
English - 1
PSS 180 A-C
0 603 366 1..
180
24 000
12 000
1.8
93 x 230
1.5
/ II
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
