MACHEREY-NAGEL NANOCOLOR Advance Guia De Inicio Rapido página 10

Ocultar thumbs Ver también para NANOCOLOR Advance:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 52
The cuvette slot cover ensures tightness according to IP67. A corresponding tightness is
therefore only ensured if the cell slot cover is placed correctly.
Fig. 4: Remove cuvette slot cover
Fig. 5: Remove cuvette adapter
Step 4: Run a test
Possible dangers of contact with chemical and biological substances.
Working with samples, reagents and corresponding accessories is associated
with dangers.
Wear suitable protective equipment when working with the cuvettes. Observe the safety
data sheet (SDS) of the test kit used.
Spectrophotometer NANOCOLOR
10
NOTICE
The device has a cuvette slot in which different
types of cuvettes can be inserted by using
adapters. The cuvette adapter for 16 mm test
tubes and rectangular cuvettes (adapter A) is
installed on delivery. The cuvette slot cover is
also attached. Before using the device, grab
the cuvette slot cover at the back and pull it
to the front for removal. (Fig. 4).
To change the adapter, first remove the
pre‑installed adapter. You can remove the
adapter by pressing lightly on the inner surace
of the adapter and pulling it out at the same
time. Then insert the desired adapter into the
cuvette slot until it clicks into place.
Adapter A: 16 mm test tubes,
10, 20, 40, 50 mm rectangular
cuvettes
Adapter B: 24 mm test tubes
WARNING
Advance 1.1, 10.2021
®
Tabla de contenido
loading

Tabla de contenido