Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7.11 LED light
The LED worklight (4) can be lit prior to motor
running.
Press the on/off switch lightly, to keep the work area
lighted.
It also lights during operation.
WARNING:
Do not stare directly at the light beam. Never aim the beam at any person or an
object other than the work piece.
Do not deliberately aim the beam
at persons and ensure that it is not directed
towards the eye of a person for longer than 0.25s.
7.12 Battery level indicator
The battery level indicator (5) will light to show the
battery level when press ON/OFF switch (7) When
release the ON/OFF switch, the light will be off.
When the battery level indicator lights in red, the
battery level is low and should be charged.
7.13 Belt clip
This cordless drill has a belt clip (10) which convenient for
carrying on the operator's belt . The belt clip can be
installed on the both sides of bottom of cordless drill. Place
the belt clip onto t he groove and put the screw through the
screw hole, use the screwdriver to turning it anticlockwise
and finally check the belt clip lock firmly.
Disassembly:
Remove the belt clip in the opposite way.
NOTE:
To prevent losing the nut on the inside of battery
port when installing or dismounting the belt clip.
7.14 Drilling
Before drilling, the torque setting should be set on the drill
position " ".
When drilling hard smooth surface, use a center punch to
mark the desired hole location. This will prevent the drill bit
from slipping off center as the hole is started. Hold the tool
firmly and place the tip of the drill or bit into the work piece,
applying only enough pressure to keep the bit cutting. Do
not force or apply side pressure to elongate a hole.
11
Tabla de contenido
