Active AGi3500 Manual Del Usuario página 60

5. OPERATION:
Battery charging.
TIP:
• The generator DC rated voltage is 12V.
• Start the engine first, and then connect the generator to the battery for charging.
• Before starting to charge the battery, make sure that the DC protector is turned on.
1. Start the engine.
2. Connect the red battery charger lead to the positive (+) battery terminal.
3. Connect the black battery charger lead to the negative (-) battery terminal.
4. Turn the ESC "OFF" to start battery charging.
NOTICE
• Be sure the ESC is turned off while charging the battery.
• Be sure to connect the red battery charger lead to the positive (+) battery
terminal, and connect the black lead to the negative (-) battery terminal. Do not
reverse these positions.
• Connect the battery charger leads to the battery terminals securely so that they
are not disconnected due to engine vibration or other disturbances.
• Charge the battery in the correct procedure by following instructions in the
owner's manual for the battery.
• The DC protector turns off automatically if current above the rated flows during
battery haring. To restart charging the battery, turn he DC protector on by pressing
its button to "ON". If the DC protector turns off again, top charging the battery
immediately and consult a franchised dealer.
TIP:
• Follow instructions in the owner are manual for the battery to determine the end
of battery charging.
• Measure the specific gravity of electrolyte to determine if the battery is fully
charged. At full charge, the electrolyte specific gravity is between 1.26 and 1.28.
• It is advisable to check the specific gravity of the electrolyte at least once every
hour to prevent overcharging the battery.
60