Install The Battery Pack; Remove The Battery Pack; Operation; Important - GreenWorks 21332 Manual Del Operador

EN
8.4

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.5

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (16).
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand
the safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

CONTROLS

9.2

START THE MACHINE

1. Pull back on the lock-out button (3) and pull the
trigger (1).
9.3

STOP THE MACHINE

1. Release the trigger to stop the machine.
WARNING

IMPORTANT

WARNING
English
9.4 ADJUST THE LENGTH OF THE
CUTTING LINE
The machine has an auto-feed head. It will damage
the machine if you hit the head to try to advance the
line.
If the cutting line does not automatically advance, it
can be tangled or empty.
1. When the machine is on, release the trigger.
2. Wait two seconds, push the trigger again.
3. Resume trimming.
The line will extend approximately 0.4 in. with each
stop and start of the switch trigger until the line
reaches the cut-off blade and the cut-off blade cuts the
excess length.
9.5 ADJUST THE LENGTH OF THE
CUTTING LINE MANUALLY
1. Stop the machine.
2. Push the spool retainer button (17) and pull on
cutting line to manually advance the cutting line.
3. After you extend new cutter line, always return the
machine to its normal position before you start it
again.
8
NOTE
NOTE
NOTE