Operation; Starting And Stopping The Engine; Mowing - Grizzly BRM 51-170 A-OHV Q-360 E-Start Traducción Del Manual De Instrucciones Original

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 184
GB
2. Should the front wheels remain
able to move freely, lift the
clamping brackets (28) and do
not place them in the opening,
but rather set them on the plate
beside it.

Operation

Observe noise control and local
regulations.
Starting and Stopping the En-
gine
Warning! Petrol is flammable.
Start the engine at least 3 m
away from the filling location.
Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
For your safety: Stand behind the
device when starting it..
Regularly check petrol and oil level
(see „Initial Operation") and refill in
due time.
Starting the engine with
starter handle (manual)
1. When performing a cold start, press
the fuel pump (
times. When performing a warm start,
begin as described in section 2.
2. Pull the safety catch (3) towards the
handle bar and hold it.
3. Pull the starter cord (22).
110
31) (red button) 3
4. When the engine starts, allow the
starter handle to slowly slide back into
the starter cable guide (21).
Starting the engine with electric
starter (E-Start)
1. When performing a cold start, press
the fuel pump (
times. When performing a warm start,
begin as described in section 2.
2. Pull the safety bracket (3) towards the
handlebar (1) and hold it.
3. Press the start button (36). The motor
starts.
Stopping the engine:
Release the safety loop (3). The motor
switches off and the knife is braked.
For a warm start it is not neces-
sary to press the primer (
If the primer is pressed too often,
too much petrol will enter the car-
burettor and the motor is difficult to
start.
Regularly examine the knife
stopping device:
Release the safety loop (3). The
motor switches off and the knife is
braked. The knife must stop within
7 seconds.

Mowing

1. Start the engine (see
2. Wheel drive:
On: Pull the drive catch (
the handle bar. The mower moves for-
wards.
Off: Release the drive catch (
equipment stops.
31) (red button) 3
31).
/
).
2) towards
2) The
Tabla de contenido
loading

Tabla de contenido