Fitting The Wheels; Assembling The Grass Box; Operation; Hanging On/Removing The Grass Box - Grizzly ERM 1231-2 G Traducción Del Manual De Instrucciones Original

GB

Fitting the wheels

D
1. Slide the wheel screw joint (5a)
through the middle hole of the
wheels (5).
2. Screw the wheels (5) down into
the desired place. All wheels
must be set to the same height.
There are three possible posi-
tions.

Assembling the Grass Box

E
1. Connect the two pieces of the
collection box (16).
2. Connect the handle (15) in one
of the two pieces of the collec-
tion box (16).
Do not work with the lawnmower
without the collision guard or
lawn box. There is a risk of in-
jury.

Operation

Hanging On/Removing the
Grass Box
F
1. To hang on the grass box (4), lift
the collision guard (7) and hang
on the grass box. Fold the col-
lision guard (7) onto the grass
box (4). It holds the grass box in
the correct position.
2. To remove the grass box (4),
lift the collision guard (7) and
detach the grass box. Fold the
collision guard (7) back onto the
mower housing (6).
50
Level gauge:
The level gauge (4a) is located on the
side of the grass catcher (4).
Flap open:
grass catcher empty
Flap closed:
grass catcher full

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The lawn mower can be adjusted to the
following cutting heights by changing the
position of the wheels:
60 mm - Tall cutting height
40 mm - Medium cutting height
20 mm - Short cutting height
D
1. Unscrew the wheels (5).
2. Firmly re-secure the wheels
(5) in the required position. All
wheels must be adjusted at the
same level.
The correct height is around 30 – 45 mm
for a decorative lawn and around
mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
Observe the noise protection and
local regulations.
45 - 60