Making Cuts - Flex MS 1706 FR Instrucciones De Funcionamiento

Instruction manual
extraction system. Follow the operating
instructions for the dust extraction
system! Check the attachment!
If required, use an appropriate adapter.
NOTE
If your dust extractor requires a special
connector, the clip-on connection can
be removed and a matching adapter
selected from the FLEX accessories
range.

Making cuts

DANGER
The stipulated cutting direction is
indicated by the cutting-direction arrow
(10.) on the guard hood and must
always be observed.
Always guide the wall chaser with both
hands. Use the designated gripping
areas. One hand on the power tool, the
other hand on the handle (4.) or (7.).
If there is a risk of cutting through live
cables, do not touch the metal parts of
the machine.
Diamond cutting discs become very hot
during operation. Do not touch them
until they have cooled down.
1. Position the power tool milling
table (1) fully on the area which is to
be processed.
12
To align with marks, use the notch
in the milling table.
2. Switch on the device.
3. Press the release rocker (8.) and
slowly lower the milling unit and
immerse into the material.
4. Move the wall chaser in the
indicated cutting direction.
5. After making the cut, swivel the
power tool – with the motor running
– all the way out of the groove until
the release rocker (8.) engages.
NOTE
When the power tool is switched off, the
tool continues running briefly.
6. Switch off the power tool.
7. Remove the remaining web with the
supplied web remover.
Swivelling the motor unit
To improve guiding the cut and
handling, the drive unit can be
swivelled.
MS 1706 FR