HAMPTON BAY BAYWOOD Guía De Uso Y Mantenimiento página 8

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy bottom cover (C) from the canopy (B) by
turning the bottom cover counterclockwise until it unlocks.
□
Loosen the two canopy screws (GG) located in the
bottom of the mounting bracket (A), and turn the canopy
counterclockwise to remove the mounting bracket (A) from
the canopy (B).
A
GG
B
C
3
Assembling the fan
WARNING: Failure to properly install the locking pin
could result in the fan becoming loose and possibly
falling.
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(RR) must be completely tightened
□
Loosen, but do not remove, the two setscrews (ZZ) on the collar
on top of the motor housing (F).
□
Align the holes at the bottom of the downrod (D) with the holes in
the collar on top of the motor housing (F).
□
Carefully insert the hanger pin (CC) through the holes in the
collar and downrod (D). Be careful not to jam the hanger pin (CC)
against the wiring inside the downrod (D).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the two setscrews (ZZ) on the collar on top of the
motor housing (F).
2
Routing the wires
□
Route the wires exiting the top of the fan motor assembly (F)
through the center of the canopy bottom cover (C).
□
Make sure the opening of the canopy (B) is on top and insert
the ball/downrod (D) through the canopy (B).
□
Route the wires exiting the top of the fan motor assembly (F)
through the downrod as shown.
D
B
C
E
F
CC
F
7
Please contact 1-855-HD-HAMPTON for further assistance.
D
DD
ZZ
HAMPTONBAY.COM