Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Align the holes in the seat pan with the holes for
the upper position (C) or the lower position (D).
Install the bolts and the nuts.
4. Tighten all bolts fully.
To connect the battery
WARNING:
and burn injuries. Do not use metal
wristbands or other metal accessories.
Metal items that touch the battery
terminals can cause burn injuries,
electrical shock, and short circuit of the
battery.
Note:
If it is after the year and month that is written
on the battery label, charge the battery. Charge the
battery for a minimum of 1 hour at 6–10 A.
1. Find the battery location below the seat or the
engine cover.
2. Lift the seat pan or the engine cover to the raised
position.
3. Remove the 2 terminal caps (A) and discard
them.
4. Connect the red battery cable to the positive (+)
terminal and tighten the bolt and nut as shown.
Move the terminal cover on the terminal.
WARNING:
red battery cable must be connected
to the positive terminal before the
black battery cable is connected
to the negative terminal. This is
to prevent sparks and accidental
grounding.
5. Connect the black cable to the negative (-)
terminal and tighten the bolt and nut fully.
6. Apply petroleum jelly on the battery cables to
prevent corrosion.
12
Risk of electrical shock
A
Risk of sparks. The
7. Lower the seat pan or the engine cover.
To move the product off the skid
1. Lift the cutting deck to its highest position. Use
the lift lever.
2. Push the clutch/brake pedal down to release the
parking brake.
3. Put the freewheel control in the "Transmission
disengaged" position, refer to
storage and disposal on page 37 .
4. Push the product forward off the skid.
5. Remove the strap that holds the deflector
protection up against the product.
To do a check after the assembly
•
Make sure that all assembly instructions are
completed.
•
Make sure that no remaining parts are in the
package.
•
Make sure that the battery is prepared and
charged correctly.
•
Make sure that the bolts for the seat are
tightened and that the seat is adjusted correctly.
•
Make sure that the tires are correctly inflated.
•
For best cutting results, make sure that the
cutting deck is balanced side to side and front
to rear. Make sure that the tires are correctly
inflated for a balanced cutting deck.
•
Examine the cutting deck and the drive belts.
Make sure that the drive belts are installed
correctly around the pulleys and inner part of all
belt keepers.
•
Examine the electrical wires. Make sure that all
wires and connections are safe.
•
Make sure that the freewheel control is in
the "Transmission engaged" position. Refer to
Transportation on page 37 .
•
Make sure that the engine oil is at the correct
level.
•
Make sure that the tank is filled with the correct
type of fuel.
•
Make sure that you know the location and
function of all controls.
•
Make sure that the brake system is in safe to
operate condition.
•
Make sure that the Operator Presence Control
(OPC) and the Reverse Operation System (ROS)
operate correctly. Refer to
operator presence control (OPC) on page 7 and
To do a check of the reverse operation system
(ROS) on page 7 .
•
Remove the air from the transmission before
To remove the air from the
first use. Refer to
transmission on page 31 .
Transportation,
To do a check of the
1940 - 006 - 13.09.2022
Tabla de contenido
Solución de problemas
