Inserting/Removing Battery; Storage; Cleaning; Service And Repair - RIDGID RBC-121R Manual De Instrucciones

Figure 7 – Inserting Battery In Charger
Inserting/Removing Battery In
Tool
1. With dry hands, insert battery into tool
receptacle. Battery only fits into receptacle
one way. If the battery will not fully seat
into the receptacle, do not force. As the
battery is inserted, the tabs will engage
the tool to retain the battery in place.
2. To remove battery, depress tabs and
pull straight out (Figure 8).
3 Always remove the battery from the tool
when making adjustments, changing at-
tachments or storing.
Figure 8 – Installing/Removing Battery In Tool
999-995-210.09_REV. C
RBC-121R Battery Charger

Storage

Store the charger and batteries
WARNING
in a dry, secured, locked area that is out of
reach of children and people unfamiliar with
proper charger operation.
Remove batteries from tool or charger before
storage. The battery packs and charger
should be protected against hard impacts,
moisture and humidity, dust and dirt, extreme
high and low temperatures, and chemical so-
lutions and vapors.
Long term storage in the fully
NOTICE
charged state, the fully discharged state or in
temperatures above 140°F (60°C) can per-
manently reduce the capacity of a battery pack.

Cleaning

WARNING
Unplug charger and remove the battery
before cleaning. Do not use any water
or chemicals to clean charger or battery
to reduce the risk of electrical shock.
Remove any dirt or grease from the exterior
of the charger and battery pack with a cloth
or soft, non-metallic brush.

Service And Repair

WARNING
Improper service or repair can make
machine unsafe to operate.
There are no user-serviceable parts for the
charger or battery packs. Do not attempt to
open charger or battery packs, charge indi-
vidual battery cells, or clean internal compo-
nents.
For information on your nearest RIDGID In -
de pendent Service Center or any service or
repair questions see Contact Information sec-
tion in this manual.
7