Loose Parts; Assembling The Blower Tubes - Toro 66100 Manual De Instrucciones

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Description
Blower cannon
Middle tube section
Nozzle section
Backpack
Blower cannon assembly

Assembling the Blower Tubes

1. Slide the channels of the middle blower tube section over the posts on the blower tube cylinder, and
rotate the middle section to secure it (A of
Note:
When the post is fully rotated into the channel, the pieces should not be able to rotate.
2. Slide the channels of the nozzle section over the posts on the middle section, and rotate the nozzle
to secure it (B of
Note:
The nozzle can be installed in either the extended or standard position for ergonomic preference.
1. Extended position
Figure 3).
Qty.
1
1 Assemble the blower tubes.
1
1
Install the blower cannon.
1
Figure 3).
Figure 3
2. Standard position
8
Use
g365122