Tabla de contenido
Trouble Shooting Method
For some troubles, the machine buzzer will ring and alarm, and the indicator will flash.
Indicator Light
Troubles
No indicator
No indicator
Breakdown
No indicator
No indicator
Standing
drain
Spin
malfunction
A conflict
between the
tub and the
cabinet
during
spinning
Insufficient
water supply
Unavailable
preset
function
Abnormal
water level
sensor
Unstoppable
inlet or
automatic
drain
Memory chips
break down
Unending process
Fail to power
or no indicator
off or power
on
Possible Cause
The plug is badly connected
to the socket or the switch is
not activated.
The socket is dead or the
fuse is broken.
The current process is lost
for power failure
The voltage is too low or too
high
E1
1.The drain hose is blocked;
2.The drain hose is
90cm
E2
The lid is unclosed during spin,
or use under glaring sunlight
The clothes are not laid evenly
in the tub.The machine will try
E3
to make a automatic check
and ajustment for 2 times,or if
nothing available ,an alarm
will be given.
The tap is closed,water supply
is cut off or water pressure is
E4
too low,so the water fails to
reach to the desired level for
quite a long time.
The lid is unclosed during
E5
preset process(the process
will pause and an alarm will
be given)
The sensor fails for short or
E6
open current,etc.and an alarm
will be given.
E7
Abormalities occur in PCB,
inlet valve or water level
sensor
E9
It can not be read or wrote
PCB is broken.
hung up over
English-12
Solution
Connect the plug properly or
activate the switch
Contact the authorized
technician.
Reuse only when power failure
is eliminated
Remove the plug and reuse it when
the voltage comes to normality.
Check the drain hose,open the
lid and then close it to continue
drain process.
Close the lid or use it indoor
Open the lid,distribute the clothes
evenly in the tub and then it.
Open the tap or use the machine
after the water pressure comes
to normal.Open the wash lid,
close it and restart to input water.
Close the lid.
Contact the authorized
technician.
Cut off the power after draining ,
and try to contact with the
authorized technician.
Contact the authorized technician.
Contact the authorized technician.
Tabla de contenido
