Tabla de contenido
co n n e c t i on of the dr ain h o s e
1. Hitch the sealed loop over the
joint.
joint of drain hose
sealed loop
Laundy tub drain system
T op of tub must be no higher than 90cm from
bottom of waster(A)
co n n ec t i o n of the i n le t h o s e
Outlet:
1.Select the appropriate type
of outlet as shown in the figure.
Installation and connection of the inlet hose
1.Unscrewing the part "a" from the water faucet.(As figure 1)
2.Respectively attach the water inlet hoses to the water faucet.(As figure 2)
Note: Do not overtighten. Damage to the valves can result.
2. Press down the fix ring, and
hitch it over the drain hose.
Needs a 3cm minimum diameter standpipe with
minimum carry away capacity of 30liters per minute.
T op of tub must be no higher than 90cm from
bottom of washer(B).
A
2.End of outlet spout should be more than
10mm, or the connector cannot be assembled.
English-5
3. Press down the fix ring, and
then push it to the drain outlet.
Clasping the fix ring to make
sure they are connected well.
Standpipe drain system
B
3.Water leakage is
possible from here.
Tabla de contenido
